This item is an edelbrock F4b 4bbl aluminum intake for a ford small block 260, 289 and 302. The intake was aquired with a vehicle purchase. The intake has low miles of run time and looks like new.

The intake was bead blasted and freshly coated in a high temp cast aluminum. The intake is protected from corrosion and looks great like new, actually better than new. The coating is listed to be be good to 500 degrees and resistant to most chemicals including gasoline and oil.

This intake manifold is not like any other you might find available as 98% of any others you might find will have extensive corrosion wear at the water ports and at the thermostat mounting area.

This is normal wear with the intakes being run with a good amount of miles on them, also most of them will need work at the machine shop to replace stripped bolt threads as this is a common thing to happen with steel bolts and fittings, as they freeze up with aluminum.

Also after you have an intake manifold cleaned, you may uncover cracks and any other damage hidden under grease and dirt. 

None of this is the case with my intake manifolds, mine are cleaned to the bare metal, and have any damaged bolt threads replaced, and mine only has a small amount corrosion wear, which mine are as close to new as your going to get.

These intakes are great horse power makers and they run a high 6000 + rpm. They have not been made since the 1960's and are getting extremely hard to find.

I have 4 of these intake manifolds, all are in excellent condition. One bid is one intake manifold.

This is the more rare early model that just has the throttle cable mounting on the side of the intake runner.

I was told this intake was the lat1 option on the sunbeam tiger.

This intake is very similar to the cobra intake, only made by edelbrock.

These intakes look super great on old mustangs and many other fords.

I have seen many of these rare intakes sell for well over $500.00 and they were in no where near as good of condition.  This intake will run as good or better than the performer rpm model, looks far better and this intake will hold its value far better.

The intake would look great on an old vehicle, such as an old mustang or just about any classic ford or mercury. 

The intake has no surprises, it has been professionally inspected, and found to be in excellent like new condition. All bolt threads are cleaned and in excellent condition. The intake is 100% ready to bolt on and run. No prep is necessary, just bolt it on and go !!!!

This item will ship with ground shipping, the auction lists UPS ground, but it may also ship either Fed ex ground or USPS ground advantage, depending on whatever is most convenient at the time of shipping.

We do not have open hours for local pick ups, however a local cash pick up can be arranged if you contact me before bidding so we can make sure I can arrange a day and time to be here for you to pick up the item.


Please ask any questions before bidding. Thank you for your interest.