Features:
Direct fit to 2 1/2 inch (74.5mm) Metal Tube
Allow weight of cables and wires to rest on Support instead of wind turbine or slip rings Stabilize cables inside towers
Cables will never snap again due to its own weight
Can easily handle 50lb of weight
Light weight aluminum
Resist Corrosion - Aluminum will not rust!
Cutaway Diagram:
|
|
Demo Pictures Only.
Wind Generator, Tower Adapter, Metal Pipe and Colored Cables are NOT included
Tower Adapter can be purchased separately here:
![](https://greenergystar.com/eBay/Energy/Wind/TowerAdapter49mm-3in%28alu%29[gs].jpg)
|
Installation Overview:
When installing the cable support, it is not necessary to cut the pipe in half. Below is for demonstration only.
Wind Generator, Tower Adapter, Metal Pipe and Colored Cables are NOT included
- Tie cables to support as shown in pictures above
![](https://greenergystar.com/eBay/Energy/Wind/cable-hanger-step2[gs].jpg)
- Place cable support on a 74.5mm (3 inches) wide metal tube.
![](https://greenergystar.com/eBay/Energy/Wind/cable-hanger-step3[gs].jpg)
- Install the Tower adapter or Wind Turbine to cover up the cable support.
Specification:
|
Material |
Light Weight Aluminum
|
|
Diameter |
73.5mm |
|
Compatible hardware |
2 1/2 inch (74.5mm) Metal Tube
GreenergyStar Tower Adapter |
|
Weight |
52g, 1.9oz |
|
NO OPERATING COST
GENERATES ELECTRICITY FROM THE ABUNDANT RESOURCE
|