New RV LED Awning Light Set

16' Feet of super bright RGB color changing LED Lights to light up your RV.  This light set comes with a 20 key IR wireless remote that can sync to music.  It is sound activated that will beat with your music.  Or you can use it as a regular remote with a steady stream of light.

This is a RGB LED Light Strip 16' that is fully Waterproof.  These lights are meant to last and does not need to be taken on and off or plugged and unplugged every time you open and close your awning.

This kit is specifically designed for recreational vehicles.   The strip is held in place by it's adhesive 3M backing

What's included in this kit:

• 1 x 16' Pc. of 5050  Waterproof LED strip light w/Wire lead.  This LED Light strip is RGB which can switch from white, blue, green, red and any combination of the 4 colors to create tons of different color combinations.
  
  
• 1 x 20 key IR wireless remote control with color changing capability and music sync flashing effects.  It has both different flashing and strobing modes as well as static colors just like our other sets.  Change from a cool subtle color change or a fast and vibrant strobe effect.
  
  
• 110v power cord

How to install

• This strip can be mounted in many places; best place for mounting the LED Awning light is just under the Awning lip that is fastened to sidewall of your RV.  This will allow the LED awning light to be hidden and protected with the awning when closed and revealed when the awning is in the open position. This is the most permanent, safest and easiest place to mount the awning light. When locating the light on the sidewall side of the unit it produces much better light and will not shine in your eyes while sitting under your awning.
• Select the location where you want to mount the light, take in account how you want to get the 12 volt power to this strip. We suggest starting the wire end of the strip near your RV power source.
• Clean the mounting surface with 3M adhesive promoter if possible, if not just use rubbing alchohol. Remove the 3M backer and install end to end along the awning extrusion. Please be careful and plan ahead, this channel will not come off once it has been applied.
• Remove the 3M backer from the LED strip, then apply.
• Connect the Strip light wire lead to any 12V or 110v  switched source and enjoy your new LED Awning light for 50,000 plus hours.
• Note: This is very easy for any DIY to do.  

 

Don't forget to add any of our accessories like our 3ft or 16 ft -

4 wire extension so you don't need to wire your receiver box so high.  

We also sell additional IR and RF remotes that can be switched out 

for different uses as well as replacement plugs and adaptors.   Just 

ask us and we can send you a link or look in our ebay store.