New RV LED Awning Light Set
Super bright white LED Lights to light up your RV, camper, pop-up, boat or deck. Endless possibilities to where you can use these.
This is a bright white LED Light Strip that is fully Waterproof. These lights are meant to last and does not need to be taken on and off or plugged and unplugged everytime you open and close your awning.
The strip is held in place by it's adhesive 3M backing
What's included in this kit:
- Your choice of length of super bright 5050 RGB LED strip light .
- 1 x 110V power cord/plug if selected. Can easily converted to be wired in direct to your power source as well.
- Your choice of remote control. If no remote control is needed, the light set will come with a direct female plug.
Remotes:
- 3 button In-Line controller. Toggle between different flashing modes, flash rate and brightness
- 10 button In-Line RF Remote Control. This remote uses radio frequency (RF), so it can be controlled through walls. Control flash rate, modes and brightness.
How to install
- This strip can be mounted in many places; best place for mounting the LED Awning light is just under the Awning lip that is fastened to sidewall of your RV. This will allow the LED awning light to be hidden and protected with the awning when closed and revealed when the awning is in the open position. This is the most permanent, safest and easiest place to mount the awning light. When locating the light on the sidewall side of the unit it produces much better light and will not shine in your eyes while sitting under your awning.
- Select the location where you want to mount the light, take in account how you want to get the 12 volt power to this strip. We suggest starting the wire end of the strip near your RV power source.
- Clean the mounting surface with 3M adhesive promoter if possible, if not just use rubbing alcohol. Remove the 3M backer and install end to end along the awning extrusion. Please be careful and plan ahead, this channel will not come off once it has been applied.
- Remove the 3M backer from the LED strip, then apply.
- Connect the Strip light wire lead to your source and enjoy your new LED Awning light for 50,000 plus hours.
- Note: This is very easy to use.
Don't forget to add any of our accessories like our 3ft or 16 ft - 4 wire extension so you don't need to wire your receiver box so high.
We also sell additional IR and RF remotes that can be switched out for different uses as well as replacement plugs and adaptors. Just ask us and we can send you a link or look in our ebay store.