4 Port Oil Filter Adapter Plate
3/4UNF16 1/8"NPT
This is a great product to make
installing your Oil Pressure and Oil Temperature senders easy. Made from
aluminum, this plate screws on under your oil filter and it has (4)
1/8" NPT fittings. So, no more drilling and taping holes. Just unscrew
your oil filter, screw the plate down in the same manner as you would
install your oil filter, and then screw your oil filter back on and
install our Oil Pressure or Oil Temperature senders. Comes with 4 plugs,
O-ring gasket and instructions. The plate can even be rotated 360
degrees give you the most room to install the senders.
*This
plate will make your filter stick out 29mm or 1.15" more so check if you
will have any clearance issues. Some WRX's will need to bend or trim
some heat shielding.
We carry these in five sizes:
3/4 UNF-16 - Fits Mazda with spin on conversion, some Nissans, VW, Ford, BMW, Scion, SRT-4, SR20, Toyota & Jeep
M20 x 1.5- Fits
most Subaru, Non-metric Honda, Mitsubishi, Acura, Hyundai , Nissan
Sentra 2.5L, 350Z, & Mazda RX-7, Porsche, RX-8 & Honda S2000
Note:-Some modification required for 06'-07' TR edition to make this fit. You may also consider our Remote Oil Pressure Kit.
M22 x 1.5 - Fits
Mazda 6 (6 cylinder), Ford 6.8L super duty, 4.0L Mustang, Explorer,
sport trac, Mustang GT 4.6L, 5.4L F-Series, Metric Mercury V6/V8,
Metric Honda Civic/CRX & Some Metric Chevy's and Fords.
3/4 UNF-16-Long Shaft- Fits Toyota Celica, Scion Tc, & MR2
13/16 UNF-16 - Fits
most early 4, 6 & 8 cyl. Chevys,(305, 5.0, 5.7) Some 4,6,8 cyl.
Buick, Pontiac & Oldsmobile. Does not fit big blocks or 350 Gen 1.