Hoover press n snap
Description
Multivariation
Hoover press n snap - You will get the tool complete with the 4 snap dies
Hoover press n snap with dies - You will get the tool complete with the 4 snap dies + 2 #1 eyelet dies (5/16" Inside Diameter)
Rubber retainer - You will get the rubber retainer only
Cap die - You will get the cap die only
Socket die - You will get the socket die only
Post die - You will get the post die only
Stud die - You will get the stud die only
Description
UK's best price for the best snap fastener machine tool. The hoover press n snap tool makes light work of fitting snap fasteners. It is what most professional would use on a day to day basis. No need to cut holes or use a hammer. You can also fit fasteners with no need to take the cover off each time.
How to use
To remove dies from tool pull/twist.
To install dies onto the tool push/twist.
Select and attach the appropriate die set for the job at hand. With the handle closed Adjust the end bolt until the two dies come in contact, being careful not to cut the M2700 gray retaining ring. Insert a cap into the rubber ring (FULLY) and snap a socket onto the metal die. Place fabric between the dies and press / squeeze the handle. Fasteners should not rotate when set in fabric. CAUTION: Over tightening may cause distortion to fasteners and dies. It is advisable to make several practice settings.
We also have a listings for the snap fasteners below. All our snap fastener work with this tool
Here is a picture to show the terminolgy of the snap fasteners
About us
We are a family run business specialising in canopy fasteners and also have a large range of marine grade stainless steel fittings. We set up to help the end user with fitting canopies and doing a little DIY around their boat. In the past I designed and manufactured canopies up and down the country myself, I have the knowledge to advise and recommend specific fasteners you may require. Products are carefully sourced to ensure the best quality at reasonable prices.
