1185kV Brushless Motor + 60a ESC + Propeller Kit Combination - Designed for 3 cell Lipo Battery Packs  
 
485 watts, 1.9 kilograms of thrust, 50mph pitch speed

The largest motor kit in my shop.

The 60A ESC I have at the moment is black and branded "Hornet" but it is supplied by Keda and the quality is good.

Sent from the UK by Royal Mail

Just added to the range of kits on my shop is this large high torque motor, a lower KV rating than the other large motors I sell which means it can turn a large 11x5.5" propellor for lots of thrust with slightly lower speed and good effeiciency.

Suitable for models from about 2kg / 4.5lb all up weight up to 4kg / 9lb depending on performance required. All types of models such as foam warbirds, small trainers, small sports models, Piper Cubs, gliders etc. Both prop and motor can be used in a pusher or tractor (rear or front mounted) configuration.

Included -
  • High quality outrunner motor,
  • APC style 11x5.5" prop. Colour may vary.
  • 60amp Speed controller with BEC to power your receiver and servos (not always included in larger ESCs)  
  • Choice of prop adapters and mounts to mount the motor either way round (Comes with everything in the photos)
  • Connectors are also included and pre-soldered for the connection between speed controller and motor.
The prop I have provided gives the maximum power from this motor with a 3S pack. 

I have measured the performance on a test bench and here are my results (better than using a computer simulation!)

On a 3s 2200mah 25c battery with the supplied 11x5.5 inch prop
Voltage 10.5v
Current 46 amps
Power  485 watts
Prop speed 10,400 rpm
Thrust 1.9kilograms
Pitch speed 50 mph

 
Motor and Esc have pre-fitted 3.5mm gold bullet connectors to connect them together.  The battery connectors are left bare.  There is no standard for battery connectors , you should buy a suitable connector to suit your battery type and solder it on.  To avoid soldering you could buy suitable screw terminals and buy a battery connector with bare wires.

Specs:

Prop
1x 11x5.5 APC style prop
Adapter rings to suit various different prop adapters
Motor Specs:
Model: 1185kv
Motor Diameter: 37.4mm
Motor Length: 42mm
Shaft Diameter: 5.0mm
Shaft Length: 20mm
Weight: 152g
Mounting Hole Size: M3.0, pitch 25mm
Mounting Hole Depth: 4mm Max.
Bolt thread: M3 (standard 3mm bolt)
Connection: 3.5mm Bullet-connector

60A Keda ESC (Hornet Branded) with BEC
Programmable but works out of the box for aircraft no programming required, programming instructions provided.
Built in BEC to power the receiver and Servos
 
Propellor Mounting options
There are 2 mounting options, both are provided with the kit:
 
Front mount, this means the front of the motor is screwed to the bulkhead (wooden plate) of the model.  The shaft sticks through the bulkhead and the prop goes on the front of the shaft.  
Rear mount option, provides a cross shaped mount to mount the rear of the motor to the bulkhead, plus a 3 holed machines prop holder that screws to the other end of the motor, screws provided.
 
 

Please note this is not a toy, it is a powerful motor and could be dangerous if not used safely.