Syltech Isolator Terminal Kit (2 in a kit) - Designed for bulk head and firewall junctions where large amounts of current needs to pass through metal objects without shorts or cavity leaks.
Perfect for fuel pump upgrades like Walbro 400's, 460's, 520's and Bosch 040's which require large amounts of current to pass through fuel tank bulk heads. Standard wiring cannot keep up with the amount of AMPs required for these high performance pumps and are known to melt over time. Having the incorrect wire gauge for upgraded internal pumps is very dangerous as it can cause shorts and potential fires around fuel.
These isolators ensure a fixed terminal sealed from fumes and fluid without shorting with its base conductive surroundings. These isolators are ethanol safe with fuels such as E85 as well which make it a must for any fuel setup upgrade!
Technical Information:
Type: Bulkhead Electrical Isolator Terminal (2)
Maximum Power Rating : 50AMP
Fitting Composition: Polyoxymethylene
Seal Composition: Viton
Stud Composition: Stainless Steel
Stud Diameter: 6mm
Stud Length: 30mm
Connection: M6 terminal for eyelet wire crimp
Kit includes:
2x allen key studs
4x nylock fasterner nuts
8x terminal washers
4x viton seals
4x machine lathed terminal blocks
2x external protective dust boots
1x datasheet & instruction manual to ensure correct installation
For more info on installation please refer to the spec sheet within the images or please do not hesitate to message us!
Correct installation is crucial to the safe use of these terminals and any error can cause serious damage. AutoSupplies_AU takes no responsibility for any damaged caused. Please read the installation instructions well before use.