Auto Locksmith Ignition Inspection Loop to Check Immobiliser System Test Tester

Auto Lock Ignition Inspection Immobiliser Loop Test

Usage

Auto Lock Inspection loop is indispensable for the locksmith

Checking auto lock loop, if light on means the lock has no problem;  if no light on means the lock loop has a problem. if you have a light on but can't start  car, means the chip has a problem.

Works On Key Ignitions ONLY will Not Work On Push Button Start, Smart Key etc 

Instructions:

Place the Loop over the ignition switch.

Introduce the ignition key through the hole and into the switch

In most applications when the key is turned to the ignition on position, the Loop Led will flash once to signal that communication between the key and transponder antenna is correct.

On some vehicles, when the key is in close proximity to the ignition switch, the LED may flash before the key is even turned. This is also an indication of good communication.

Please note ;

The tester should be within 5mm of the transponder antenna when testing.

In some extreme cases, you may be required to remove the thick plastic cowling from around the ignition switch.

The LED is small and will need shielding in bright Light

Package including:

1pc x Auto Lock Inspection loop