This is our low as you go use your own ladder saw mill guide setup.It uses the 16" wide section of your aluminum ladder you set up your log and level the plate on one end lag bolt it on then go to the other end level that one and bolt it on. Or you can site it by looking down your log. The depth of your cut is set by the placement of the plate on the end of the log.Holding the ladder to the plate is a cord on each end so when your done you put your ladder back together like nothing happened.So what I am selling is two of the plates one for each end only.The lag bolts and ladder you should have and as always be careful when using your power equipment be safe.

The last photo is a log dog sold separately or you can get this bracket and the log dog together at a savings.

It’s holding up the log in the first photo.