Welcome to the Paper Air Force Company!  A new kind of model kit, made of reinforced paper and heavy card.  Low cost and big size!  Great for an introduction to the world of modelling.  Makes a beautiful large scale ceiling hangar or r/c airframe.  

The F4U-1A Corsair kit is offered as untested R/C prototype status or display only.  

40 inch wingspan, "Park Flyer" size.  Faster than balsa construction, there are no "stringers" or complex covering processes.  Precision scale outline.  Cut out with scissors and assemble with glue.  Includes kit for airframe only.  Propeller and landing gear not included. Glue and accessories not included.  Includes 4 separate decal markings.  A fun project.  

Pieces are cut out with scissors from light and heavy card.  All pieces needed to complete the basic airframe are included in the kit.  Kit consists of light and heavy card pieces,  figure (picture) book instructions, written instructions, peel -n- stick decals (4 schemes), and decal reference sheet.  

Specs
Wingspan: 40"
Flying weight: 36-46 ounces
Control surfaces: Flaps, Ailerons, Elevator, Rudder
4 historic decal liveries included: USS Bunker Hill Corsair, Jolly Rogers Corsair, "Lulubelle", "Marine's Dream". 

Materials listed below are not included:

Materials needed to complete the static airframe 
Comfortable Scissors
White Glue
5 minute Epoxy
Mini hot glue gun/glue sticks ($5 at craft store)
Hobby Knife
Lightweight Spackling Paste (at hardware store)
Sandpaper (rough, medium, fine)
Spray paint

Additional materials needed for a flying model (found at any hobby shop)
20-30 minute slow cure epoxy
Super Glue (or CA glue)
18 model airplane hinges
2 micro control horns
.055 or 1.4 mm music wire (2 standard wires)
4 sets of 3/8" by 2" nuts, bolts, washers. any similar size will also work

For Radio control flight
4 CH Radio, mini servos, electric engine, battery, speed control, prop, spinner