![](https://www.eusmile.com/items/TL0447/2.jpg)
» Product Specifications
- Condition: 100% new
- Color: Silver
- Material: Metal
- Heater: 12V
- Power: 40w
- Total Length: 80mm(3.15inch)
- Wire Length: 1m(39.37inch)
- Item included: 1 x V5 J-head Hotend Kit
- Suitable for : 1.75mm Filament
- Note:
1) All dimensions are measured by hand, there may be small deviations.
2) Color may vary slightly due to the color setting of each individual monitor.
» Product Description
Product Dimension:
Feature:
1) 100% new and high quality.
2) The Bowden cable lets you reduce the moving mass of the extruder and thus allowing faster controlled motion, less shaking of your machine, less energy use.
3) Faster printing! Normally the mechanism that drives the filament into the hot end (where it melts) is directly on top of the extruder. This creates problems of balance and oscillations with faster motion which you can see in your printing results and hear and feel when your machine is shaking.
4) If the filament drive mechanism is placed on a non-moving part of the 3D printer, it can be pushed into a tube. PTFE (Teflon) is useful because it is slippery: it has little friction with the plastic. This limits wear and loss of energy. The tube's other end is connected to the extruder's hot-end.
5) All metal enables working with Polycarbonate up to 300 degrees Celsius and with future materials that require higher working temperatures beyond those supported by plastic extruders and hot end.
6) The J-head is assembled with 100K NTC thermistor and Cartridge heater, not heat resistor.