Product Description

outdoor 4-in-1 dome security camera
ZG4182C security dome outdoor camera

 

4-in-1 camera
4-in-1 Security Dome Camera

Press OSD joystick to switch the output mode:

  • Default / UP for 5 seconds: CVBS 960H
  • Right for 5 seconds: TVI
  • Down for 5 seconds: CVI
  • Left for 5 seconds: AHD

ZOSI 1080P 4-IN-1 Security Wired Camera

Camera Specification

Noted:

this is a wired security camera, and it could be the additional or replacement camera for the wired security system.

  • Image Sensor: 1/3〞CMOS CMOS with IR-Cut.
  • Active Pixels: 1920(H)×1080(V).
  • Lens: 3.6mm
  • IR LEDs Amount: 24pcs, 5mm LEDs
  • IR Distance: up to 80ft.
  • Viewing angle:90 degree
  • Weather - Resistant
  • Singal mode: TVI / AHD / CVI / CVBS 960H.
 
ZG4182C works with CVBS TVI CVI AHD security DVR

This 1080p full HD camera has a built-in OSD menu that can change the 4 different video outputs：HD-TVI, AHD, CVI, and CVBS(960H)， and adjust the video settings.

Operation Mode：

Switch from AHD: Press Leftward for 5 Seconds

Switch from TVI: Press Rightward for 5 Seconds

Switch from CVBS: Press Upward for 5 Seconds

Switch from CVI: Press Downward for 5 Seconds

Noted: Default Video Mode is Analog 960H Mode

DNR

DWR

Flexible Installation

1080p Full HD

See everything in details with true 1080p HD resolution. Get clearer and smoother images/videos than 720p cameras.

Clear Night Vision

Equipped with 24pcs infrared LEDs, this camera can see up to 80ft in darkness. 3.6mm HD lens with IR-CUT captures clear image and video at night.

Flexible Installation

Mount this camera on the ceiling or on the wall. It’s simple to place it anywhere indoor and outdoor for all-round surveillance.
 
3.6mm lens & 24pcs leds, up to 80ft night vision
IP66 Weatherproof

Troubleshooting

Q: Video Loss appears where the image from my camera should be displaying on my DVR?

A: 1.Check the extension cable (power and video) is securely connected to the camera.

2.Check the video output from the camera is securely connected to a video input channel on the DVR.

3.Check the power from the camera is securely connected to a power supply.

4. The camera mode do not match your DVR.there is 2 ways to setup . (1) Press OSD Joystick “DOWN” 5 seconds,if still no picture come, try to press “LEFT” “RIGHT””UP” for 5 second, till the signal matching your DVR. (2) Make sure the signal of your DVR, Use OSD Joystick to change the mode of the camera according to your DVRs video Mode

PushAuction

DataCaciques