KiKi Fix Loose Jionts ( How to open the cap : Press and turn counter clockwise. )

Fixing loose Jionts action figure has never been so easy!

Use Kiki on : Dc universe hasbro, mattel, shf figureart, marvel legends, 

Tranformers, MAFEX, marvelselect, hottoys, mezco, Saint Seiya,

Neca, McFarlane, SIC, GUNPLA,WWE, Barbies starwars, and so much more

The new kiki bottle 

it have 2 head cap.you can swap head 

1.plastic cap 

2.needle cap

No problem with the needle cap Block again. 

if you Should washing the needle cap with water after every use

KiKi's Highlights

* Can coat

* Precession needle applicator.

* Thin enough to seep joints.

* Water base non toxic

* will not harm your figure

* slow drying ans semi flexible ( Water base )

* Dries clear

KIKI work on all type of phastic and die-cast. 

it is easy to appy and a little goes a long way.

Application instructions and tip

Coating and dropping are the two ways KiKi can be applied. 

For coating a joint ( like a ball joints ) allow Kiki to dry for at least one hour.

( Recomend 3 hours or It would be great if Kiki to dry 6-7 hours.and 

The drying time depends on the amount of KIKI solution that you drop.)  

You can recoat  as many time as you like to get the desired

effect. Some plastics like shf many take longer to dry than others.

For dropping Kiki only use small single drops into the jiont. Movie jiont 

every few minutes while drying as to not seize the joint.

Work best with pinned jionts and soft ratchets

For heavy figures allow 24 hour to dry before moving jionts

The dispensing needle get clogged quickly. Use the provided pin to unlog

if you forget move first time joints more than 48 hour. 

joints can not move. 

please use hot gun or hot water to help.  and move slow

stored at room temperature between 10° to 26°C 

tip :  If any part of the model is easy to fall off. 

       Drop some a little kiki and wait dry 

       if you want to remove it just heat