Palomar Engineers Yaesu 5000 Elite Transceiver RFI and Noise Reduction Kit, RFI Range 1-60 MHz, 24 Filters

The Yaesu FTDX 5000 is an exceptional radio and deserves an excepitionla RFI and noise reduction kit which we have designated as the "ELITE" series of Transceiver Kits. This kit is designed to be installed on your radio transceiver to reduce Radio Frequency Interference (RFI) caused by common mode current on the multiple coax connectors of your radio, the AC power input, USB, DMU, Audio, rotor, amplifier ALC/Send, mouse, mic and additional interconnect cables. The ELITE Kit has 6 ferrite ring (1.4" ID) filters and 18 ferrite snap on (1/2") filters and instruction manual. Kit can also be used for the Yaesu 5000MPThis kit will help reduce or eliminate:1. “Hot mic” RFI caused by poor grounding of antennas or common mode currents from linear amps feeding unbalanced (coax fed) antennas without baluns/line isolators.2. RFI to neighbor’s electronic devices including audio/video systems, computers, telephones, garage door openers, etc.3. RFI to your other radios, audio/video systems, computers, telephones, etc.A side benefit is a reduction in noise floor in your receiver depending on the amount of noise being introduced by common mode currents (which are blocked/reduced by the chokes in this kit). These chokes use a special mix of ferrite core material that is effective in suppressing radio frequency interference from transmitters and high noise floor on receivers. The split beads beads are easy to use, don’t require modification of the protected equipment and work in almost all cases, even when plug-in filters fail.Use of the chokes often helps cure SWR problems between transceiver and a linear amp and between transceiver and antenna tuner or direct to antenna. The DC power line choke helps keep common mode current out of the power line which could cause interference to other devices connected to the same power line if not suppressed.For additional RFI suppression, use a feed line choke at the antenna feed point to suppress common current on the coax feed line and a coax noise filter at the radio end of the coax to reduce common mode noise.If you use a linear amplifier use an amplifier RFI kit for additional RFI interference suppression.

Palomar Engineers Yaesu 5000 Elite Transceiver RFI and Noise Reduction Kit, RFI Range 1-60 MHz, 24 Filters

The Yaesu FTDX 5000 is an exceptional radio and deserves an excepitionla RFI and noise reduction kit which we have designated as the "ELITE" series of Transceiver Kits. This kit is designed to be installed on your radio transceiver to reduce Radio Frequency Interference (RFI) causéd by common mode current on the multiple coax connectors of your radio, the AC power input, USB, DMU, Audio, rotor, amplifier ALC/Send, mouse, mic and additional interconnect cables. The ELITE Kit has 6 ferrite ring (1.4" ID) filters and 18 ferrite snap on (1/2") filters and instruction manual. Kit can also be uséd for the Yaesu 5000MP

This kit will help reduce or eliminate:

1. “Hot mic” RFI causéd by poor grounding of antennas or common mode currents from linear amps feeding unbalanced (coax fed) antennas without baluns/line isolators.

2. RFI to neighbor’s electronic devices including audio/video systems, computers, telephones, garage door openers, etc.

3. RFI to your other radios, audio/video systems, computers, telephones, etc.

A side benefit is a reduction in noise floor in your receiver depending on the amount of noise being introduced by common mode currents (which are blocked/reduced by the chokes in this kit).

These chokes use a special mix of ferrite core material that is effective in suppressing radio frequency interference from transmitters and high noise floor on receivers.

The split beads beads are easy to use, don’t require modification of the protected equipment and work in almost all cases, even when plug-in filters fail.

Use of the chokes often helps cure SWR problems between transceiver and a linear amp and between transceiver and antenna tuner or direct to antenna. The DC power line choke helps keep common mode current out of the power line which could cause interference to other devices connected to the same power line if not suppressed.

For additional RFI suppression, use a feed line choke at the antenna feed point to suppress common current on the coax feed line and a coax noise filter at the radio end of the coax to reduce common mode noise.


If you use a linear amplifier use an amplifier RFI kit for additional RFI interference suppression.
×

Buy now and save!
Tell a friend Visit store Watch now

Postage info

Click the Postage tab above the listing description for more info

Click the Postage tab above the listing description for more info!

Additional delivery notes

PICK UP OPTION

Sorry, our items are NOT available for pick-up.

PAYING VIA PAYPAL


We accept PayPal on our all our items so you can shop with confidence.

Simple choose the PayPal option when proceeding through the checkout.

Additional Information

No additional information at this time

Ask seller a question

To contact our Customer Service Team, simply click the button here and our Customer Service team will be happy to assist.

Ask seller a question

© PALOMAR-ENGINEERS.COM

Click the Postage tab above the listing description for more info

Accepted Payment Methods

  • PayPal

Returns are not accepted

Buyer will pay for return shipping.


Additional Information:
All returns will be exchanged for like product or store credit provided they are returned within 30 days with original packaging and all manufactured products are in original shipped condition with unsealed product labels. All cash refunds subject to 15% restocking fee.