Description:

Designed for Polyurethane or Nylon tubing.
Made from solid brass for corrosion resistance.
Even after installation, the direction of the tube can be changed freely.
Elliptical release ring help to connect tube easily by manual, no special tools required.
Outside (and Inside where applicable) hexagonal wrench tightening.

This Quick fittings are only used for industrial automatic apparatus and can not be applied on any medicinal equipment.

Specification:

Model: Straight-way Quick Pneumatic Connector Male Thread
Material    Brass, Plastic
Male Thread Diameter:01~06
Fit Tube Outer Diameter(Blue End):4~16mm
Media: Clean Compressed Air,Vacuum
Max.Working Pressure: 1.32Mpa
Temperature: 0~60℃
Suitable to :PU Tube, Nylon Tube
Package Content    : 2~50 pcs x Quick Fittings

Size

Model specification  : PC         8        ---------------------          02

                                 ↓                                     ↓

         4: Insert 4MM outer diameter tube            M5: M5*0.8 thread outer diameter about 5MM

         6: Insert 6MM outer diameter tube            01: (G1/8, commonly known as 1 point) The thread outer diameter is about 9.7MM

         8: Insert 8MM outer diameter tube            02: (G1/4, commonly known as 2 points) thread outer diameter is about 12.7MM

        10: Insert 1OMM outer diameter tube          03: (G3/8, commonly known as 3 points) Thread outer diameter is about 16MM

        12: Insert 1 2MM outer diameter tube          04: (G1/2, commonly known as 4 points) thread outer diameter is about 20MM

        14: Insert 14MM outer diameter tube          06: (G3/4, commonly known as 6 points) thread outer diameter is about 26.8MM

        16: Insert 16MM outer diameter tube

NOTE：
How to choose a quick connector?
1. It is not allowed to pull or rotate the connecting thread and pipe part, otherwise the thread or pipe connection will fall off.
In the case of pulling or turning, a rotary joint should be used.
2. The bending of the pipe should be greater than the minimum bending radius, otherwise the pipe is easily broken.
3. Inflammable, explosive or toxic gases such as coal gas, gas fuel and refrigerant cannot be transported in the pipe.
4. General industrial water can be used.
5. The impulse pressure should be prepared and not exceed the maximum operating pressure, otherwise it will be easily damaged.
How to install the quick connector?
1. Before installation, confirm the correct model and size, and confirm that the product has cracks and scars.
2. Considering the pressure change, the length of the connecting pipe also changes, so the length should be left margin.
3. The joint box tube is not allowed to be twisted or stretched, and bears a negative torque to avoid damage to the joint and the tube.
Injury, crack or fall off.
4. When piping and fittings are screwed in, don’t cut the piping thread as fine as the sealing material.
The sheet is mixed into the tube, and when the sealing tape is used, the thread head is about 2 pitches free and not wound in the sealing tape.

In which environments are quick connectors used?
1. Do not use quick connectors in electrostatic sensitive occasions, as this will cause malfunctions and malfunctions of the system.
2. Do not use the quick connector in the occasions where sparks occur. Sparks may cause fire hazards.
3. Do not use it in an environment where cutting oil, lubricating oil and coolant are in direct contact with liquids.