These are not 100% Tailored factory fitted flaps

These a universal moulded mud flap for the front or rear of your car

These flaps screw to your wheel arch.

What you need to check before buying these that the rear arches has at least a 10mm lip to screw the flaps to ( Front arches should be fine )

Screws supplied.

A Really good tip when fitting these is to put the flaps in a bucket of hot water and let sit to the water is cool enough to put your hand into it ( 5-10Min ), This will soften the PVC Rubber up allowing the moulded rim to take the shape of the outer arch then screw into place.

 

Fittting Instructions

1. Test the position on the mud flaps on the vehicle against desired location

2. Use a marker pen to mark fixing positions on each mud flap 

3. With an 8mm drill bit, drill the marked fixing positions on the mud flaps only

4. Hold the mud flaps in position and use as a template to mark the fixing holes on the vehicle

5. With an 8mm drill bit, drill the fixing positions on the vehicle. The wheels may need to be removed for access

6. Fix the mud flaps into position with the fixings provided. Hold the mud flap in position while fitting one of the fixing screw through the mud flap and into the plug hole. Provisionally tighten.

7. Repeat for all the screws and then fully tighten into position.