Bipolar 6mm Conductive Rubber Clamps Black / TENS / estim / et312 / 2B / Electrode

Bipolar 6mm Conductive Rubber Clamps / TENS / estim / electrastim / et312 / 2B. Condition is New.   In order to experiment with bipolar play I have designed a set of 3D printed bipolar clamps. Each pair of Bipolar Clamps will be printed in BLACK PLA. These clamps come with 6mm conductive rubber tubing that takes 2mm plugs fitted into the clamping jaws. Sold as a pair.  It will be dispatched un-painted but with 6mm conductive rubber tubing already fitted. One side of each set of Conductive Rubber has blanking pins fitted to secure them in place and to prevent any chance of the two clamps shorting against each other. Your TENS cables plug secures the other end. To use both sets of clamps you will need an e-stim control box with two isolated channels to prevent any risk of the current going across the chest instead of just though each nipple. Just plug in your 2mm pins and then open up the clamp before pulling any nipple shaped object though the conductive rubber jaws. Then close the clamp and then tighten the knurled thumbscrews to apply the desired amount of pressure. Then switch on your control box and experiencing some e-stim pleasure. These clamps are perfect for larger nipples or for clamping down on the areola behind smaller nipples. The large knurled thumbscrews are fitted to nylon nuts and bolts that are used to tighten and hold the clamping jaws together. I used nylon fittings to further isolate the two pieces of conductive rubber to prevent the current using metal bolts as a shortcut. I recommend that you paint it first though to seal the surfaces with a plastic paint such as Krylon Fusion For Plastic. Private listing. I will not leave feedback unless you ask me to for your privacy.   Note: This product is supplied as is and I am not liable for any problems that arise from its use. It is sold as a novelty item and carries no warranty. Your statutory rights remain. Images shown are renderings, the printed product will show some layer lines and require a light sanding. Safety: Never put a current through the chest area. Always use a control box with isolated channels and use one channel on each nip.