How to use it?
1. Apply hot glue to the tab. Make sure the glue is not hot to avoid damaging the paint.
2. Apply the tab to the center of the tooth. Do not apply too much pressure when applying the tab otherwise you will create too thin a layer of glue between the car panel and the tab
3. Allow the glue to cool for approximately 45 to 60 seconds under the tab . tab head and lock the tab. Then rotate the eartip so that the eartips are facing right or left.
4. When using larger tabs, slide the weight towards you without too much pressure. Let the weight do the work. Use several short, quick pulls instead of one big pull. When using the smaller tabs, give a quick, strong pull as the tab will usually break the loss on the first pull. After each pull, spray alcohol on the excess tabor glue left on the panel and remove the tab or glue with the plastic razor blade. Repeat as needed.
5. If the tab comes off on its own, spray the release solution (isopropyl alcohol) on the glue and the panel to release the glue
6. Peel off excess glue with the supplied plastic razor blade or your nail.
7. Press down on all high points with the nylon knock down repeat the process as needed. Most teeth require multiple pulls.
Feature:
2 in 1 tooth extractor
2. Easy to use
3. Do not hurt the surface of the car
4.metal structure, durable
Description:
This T-bar puller is a lightweight glue tab puller tool, intended to be used to repair pressure bumps and any teeth that are not sharp or crumpled.
The tension puller works well with a hitting hammer when pulling big teeth.
It is very easy to control, anyone can remove the tooth easily by yourself.