Bicycle Brake Cable Kit for ACS Freestyle Rotor system Housing Color: NEON GREEN This kit is specifically for use with 1980's freestyle rotor systems, the most popular of which was made by ACS. A rotor is different from a gyro and has only a single cable operating the detangler device. This kit will NOT work with a gyro. The following is included: * 7' of lined 5mm outer diameter brake cable housing (Need additional feet? Purchase housing by the foot in the listing below, we will send with the 7 feet in the kit as one continuous length of housing.) * 6 nickel plated brass (rustproof) 5mm ferrules * 1 brake inner cable - 1.5mm thick X 67" long galvanized braided inner cable with barrel style knarps for BMX or MTB levers. This is used for the front brake. * 1 brake inner cable - 1.5mm thick x 120" long galvanized braided inner cable with a barrel style BMX/MTB knarp on one end (to go from your rear brake lever to the top of the rotor). On the other end of the cable is a road bike drop bar brake lever style knarp which is used from the lower section of the rotor to the rear brake. You will cut this cable in half to make the two inner cables you need for either side of the rotor.  * 2 brake lever silver aluminum end buttons (for non-threaded brake levers such as MX122, Tech 2, Tech 3, Tech 4 and Tech 6) * 3 brake cable end tip/crimps - choice of colors for no additional charge