Due to a different wire position, the servo is a little tight going in but it does fit.
I have found if you loosen the 4 bottom screws on the servo a few turns it goes in much easier.

Operating Voltage: 4.8V / 6.0V
Operating Current: 300mA / 400mA
Operating Speed: 0.15sec.60º/ 0.14sec.60º
Stall Torque: 4kg.cm / 4.6kg.cm
Size: 29X13X30mm
Weight: 22g
Dead Band: ≤3uSec
Operating Travel: 40º/one side pulse traveling 400us
Potentiometer: 3 slider/Direct Drive
Ball bearing: MR106
Gear: Metal
Connector wire: 215mm
Operating Temperature Range: -20c+60c
Spline: 25T