![](https://www.mituus.com/utiems/images/ut_spc.jpg)
- Condition: 100% new
- Color: Silver & Green & Yellow
- Material: Plastic & Alloy
- Spike Diameter: approx.6mm(0.2inch)
- Handle size: approx.10.3x3cm(4.1x1.2inch)(LxW)
- Sleeve size: approx.4.7x0.6cm(1.9x0.2inch)(LxID)
- Item included:
100 x Tire Stud Screw
1 x Sleeve Tool
- Compatible With: fit for most tire
This Is Aftermarket Replacement Item But Not Genuine
- Note:
1) All dimensions are measured by hand, there may be small deviations.
2)Please choose appropriate size of new studs in the installation process in terms of the depth of tire thread.
![](https://www.mituus.com/utiems/images/ut_des.jpg)
Product Dimension:
Feature:
1) These stud spikes bring a good anti-slip property for your tires. Add ultimate off-road capacity to your ordinary car, truck, motorcycles,etc.
2) Low ground pressure, environmentally with minimum impact.
3) Simple hand sleeve tool, to easily install and remove the anti-slip tire stud screws.
4) Suitable for 6 mm stud screws.
How to install the tyre studs?
1) Put the car tire studs into the sleeve tool.
2) Drill (using a very small bit) down from the center of chosen knob into the tire.
3) Drill a screw up from inside-out. If the angle isn't perpendicular to the tire, it'll stick out one side or the other.
Do one hole and screw at a time. Don't try drilling all the holes, then installing screw.
4) Put duct tape over the screws on the inside of the tire; sometimes it is best to use two layers of tape.
![](https://www.mituus.com/utiems/images/ut_car_hmain.jpg)
![](https://www.mituus.com/utiems/images/ut_pic.jpg)