About install kit: This is a RGB modding install kit for JVC WONDERMEGA RG-M2. Remove off an original RF out and then put a this DIN 9pin out that has protected with 3D printed holder. Pull needed signals from back side of the console board using a 9pin connector wire. Replaced DIN 9pin jack has compatible with SegaGenesis2, SegaMegadrive2 and 32X. Your RG-M2 console enable RGB output and links 32X unit also. Will introduce how to install on YouTube video. How to install Feature: Replace an original RF out to DIN 9pin out. DIN 9pin out has combined with 3D printed holder so absolute fixation. Fix the 3D printed holder using a bolt and a screw. Clean installation that is never used any sticky material in the whole process. Connect the SegaGenesis2 Scart RGB cable directly without additional any modding. Disclaimer: This installation work requires to soldering tools and skill for it. If you aren't able to do it on yourself from beginning to end, please don't buy this kit. I'm not going to any advise and any assistance to your installing work. I refuse to any monetary compensation even if you makes break a console caused in your soldering fails. And then I refuse providing replacement parts even if you lost the something parts in your manegement mistakes and physical damaged.

Kit parts detailes: --- DIN 9pin out that has protected by 3D printed holder. --- PH2.0 9pin connector wire. --- Bolt and nut. --- Screw. Not only enable the Scart RGB cable and 32X link cable but also accept the DIN 9pin composite video cable in compatible with SegaGenesis2/Megadrive2. I will accept combine shipping with other selling kits. Shipping charge is US$18 only(except some countries).