Thrustmaster TWCS throttle Slider Upgrade.

Tired of sticky throttle on your Thrustmaster TWCS?

This is the perfect upgrade to remove all stickiness to the throttle axis of your TWCS

An improvement even to brand new TWCS units

Improves smoothness of worn out units, gives a much more linear and mechanical feel

Printed in high quality black engineering resin, to ensure perfect fitment and strength

Retains original resistance adjuster

Simple to install, only a screwdriver needed.

LM8UU bearings - These offer a more mechanical feel , with slightly more resistance.

Drylin bearings -These polymer bearings, offer a very smooth linear action, but have much less resistance than the lm8uu bearings.

Detents- Uses small magnets pressed into the back of the unit, and small holders that you attach to the internals of the throttle with some double sided tape.

3 different heights are supplied, which can cover the entire range of the throttle.

Superior quality and fitment to poor resolution FDM printed PLA units

Worldwide shipping available

100s sold 100% positive feedback

If purchased with detents, a small amount of double sided tape, and some patience will be required. 

Detents are common with other units available, with instructions freely available on YouTube. Please get in contact if you have any issues