Aquarium Air Pump Water Oxygenation Bubble Maker Fish Tank Single Outlet
Air Pumps introduce oxygen into our tropical fish tanks through airline tubing and air stones. This increase oxygen in the form of air bubbles release carbon dioxide from the aquarium water. The increased oxygen benefits all aspects of your home aquarium. Live plants, beneficial bacteria, and your tropical fish will thrive with high oxygen levels in their water.
Rs-2800 Aquarium Air Pump is a high performance air pump with good air output. It is safe and has a quiet operation, offers high & low liter control and works on a power consumption of 3W, 2.5L/min.
RS 2800
Features
1 . Exterior
design, beautiful.
2 . ABS
plastic shell, safe and durable.
3 . Low
noise, strong job stability.
4 . High-quality
rubber cup and diaphragm, long life.
5 . Good air
output and contain high and low liter control.
6 . The
operation that is both safe and quiet.
7 . Long
service life and acquiring best effect with lowest power consumption.
Precautions
1 . Please
note that the voltage is consistent with the machine before use.
2 . Beware
of flooding, exposure, impact, in order to ensure the normal life.
3 . Do not
put the air pump into the water.
4 . The air
pump must be placed above the water level.
5 . Do not
oil at any time.
Disconnect
the plug immediately when the pump is damaged or falls into the water.
Clean or
replace air tubes or stone regularly to obtain maximum air output and longer
service life.
Warnings;
Before using
the pump, the socket to be installed should be checked. Faults in the outlet
can cause deterioration of the tool.
The socket
to which the pump will be installed and the position of the pump are important.
It needs to be up and far away in a place that it cannot get wet.
If the pump
is placed in a lower position from the aquarium, the pump may be broken due to
back flow. If it is required to work below, a Check Valve must be installed
between the air outlet and the air stone.
Care should
be taken to ensure that the pump is in a dry place above the aquarium. It
should not be dropped into the aquarium. If it falls, removing it from the
water without unplugging; it may cause electric shock.
If the pump
falls into water, it should dry for a few days after removing the plug by
pulling it out. After making sure that it is dry, it should be restarted.
The pump
must remain in continuous working condition. It can also work during cleaning as
long as the hose is disconnected and care is taken to prevent water from coming
out. Cleaning is recommended only if the plug has been pulled.
It should
definitely not be oiled.
Hose control
should be done once a week. For this purpose, some air should be blown from the
end of the hose and it should be checked whether there is any clogging. If
there is a blockage, the blockages should be removed by using a special hose
brush.