High Quality Analog Video over Fiber Converter,

SC interface (FC/ST optional) ,A pair

Option 1: Singlemode version up to 20Km(12.4miles) ,compatible with multimode fiber up to 500meters.

Option 2: Multimode version up to 1.5Km(0.93miles).

Feature:

1. This unit extend 1 analog video signals through a fiber optic cable to remote display devices. Optical interface: SC.

2. Applicable for Analog cameras only, Compatible for PAL, NTSC, SECAM Video format automatically. NOTE: DON’T SUPPORT 1080P/960P/720P TVI/CVI/AHD HD Cameras and SDI cameras, please read it carefully before order.

3. Suitable fiber type: universal Single-mode and multimode fiber. With RS-485 data (reverse direction) which can remotely control PTZ.

4. LED indicators can dynamic feedback link connection state and fault detection to easily monitor network status.

5. Plug and Play, No need to set up. Cost-effective, Greatly save your engineering cabling cost.

Video:

1. Video format compatible with PAL, NTSC,SECAM.

2. Video Input / Output Impedance: 75ohm(unbalanced);

3. Video Bandwidth :5Hz-10MHz;

4. Video voltage 1VP-P;

5. Video SNR ≥ 70dB;

6. Differential gain ≤ 0.7%;

7. Differential phase ≤ 0.7 °;

8. 8- bit linear PCM coding

9. Video Interface: BNC;

Data:

1.Type: RS-485 (2 wires, reverse direction).

2. Connector: industry terminal block.

3. Use for remote control PTZ.

General Index:

1. The usual time between failures (MTBF) greater than 100,000 hours.

2. Working voltage: AC100-240V, DC5V2A, with US standard plug.

3. Operating temperature: -40 +70 degree.

4. Operating humidity :0 -95 % non-condensing.

Power supply:
AC100-240V,DC5V2A.(US/EU/UK/AU Standard is optional)

Package:

1. 1x 1 channel video transmitter

2. 1x 1 channel video receiver

3. 2x External power adapters (US/EU/UK/AU optional)

4. User manual

LED indicators:

P: power supply. always on after power-on, display red light. Blinking or not on is abnormal.

F(SYN): Fiber Synchronous light, always on when TX and RX work, display blue light. If blinking or not on is abnormal, please check power supply and fiber optic connection status. Note: if fiber have big loss, no fiber signal pass through from TX to RX, the light is not on. Need to lower fiber loss.

V: video light, always on when have video signal input. not on is abnormal, not video signal outputted.