Compatibility:
Chevrolet Tracker 1.6L 1998-2000
Chevrolet Tracker 2.0L 1999-2003
Geo Tracker 1.6L 1994-1997
Mazda Miata 1.8L 1999-2005
Mazda Millenia 2.3L 1995-2002
Mazda Protege 1.8L 1999-2000
Mazda Protege 2.0L 2001-2003
Mazda Protege5 2.0L 2002-2003
Suzuki Sidekick 1.6L 1992-1998
Suzuki Vitara 1.6L 1999-2001
Suzuki Vitara 2.0L 1999-2003
Suzuki X-90 1.6L 1996-1998
About the mass air flow (MAF) sensor:
* What does a MAF Sensor do?
The Mass Air Flow (MAF) sensor measures the amount of air flow entering the intake manifold using a heated grid or wire. The PCM uses this signal primarily for fuel control.
* Where are these sensors located?
The Mass Air Flow sensor is located in the intake ducting after the air filter.
* Installing the replacement MASS AIR FLOW SENSOR(MAF):
1. Position MAF sensor in the vehicle. Make sure the airflow direction indicated on the sensor is toward the engine.
2. Install sensor to air duct seal(s), if so equipped, on the replacement MAF sensor.
3. Connect the MAF sensor to the throttle body air cleaner ducts. If the sensor mounts directly on the throttle body, install and tighten the mounting screws to 10 ft-lb. DO NOT OVERTIGHTEN!
4. Position clamps over the air duct/MAF sensor connections and tighten. Replace the clamps if necessary. (NOTE: For the MAF sensor to work properly, the sensor/air duct connections must be airtight.)
5. Carefully plug the harness connector lead into the MAF sensor.
Packaging:
1x Mass Air Flow Sensor/Meter