Packing list:
1. 2~24S battery automatical balancer
2. 400mm Test cable
3. Transfer board
4. 12V power adapter
Support switching between Chinese and English!
24 string intelligent automatic balancer manualProduct introduction
1, Support 2~24S lithium batteries (Li-ion , LiFePo4 ,Li4Ti5O12, voltage between 2V- 4.5V Lithium batteries)
2. Balance voltage will be automatically identified as the battery series of the lowest voltage
3, Automatically identify the battery series number
4. There are alarms of reverse connection, over voltage (4.5V) and low voltage (2V)
5. After the equalization is completed, it will automatically stop and alarm
6,
The balancer belongs to constant resistance discharge mode, constant
resistance value is 1 ohm (three maximum current of LiPo up to 4A, the
maximum current of LiFePo4 up to 3A)
7, The display content is rich
(each series voltage, total voltage, average voltage, the highest
voltage, the lowest voltage, the maximum difference of voltage, balance
voltage, battery series number)
8, Simple and easy to use
9, Efficient and fast
10, Single series battery input interface withstand voltage value(old version 5V~+20V, now updated version 100V~+100V)
11. External power supply 12V5A
The step of using
1. Power on this device
2. Connect the battery pack according to the marks on the balancer or the terminal board (check it correctly, then connect it)
3.
Check whether the voltage and string number displayed on the display
screen are normal, if it is abnormal, please cross check the wiring or
battery status
4. Start balancing, check whether the balancing voltage is normal, it will stop automatically after the balancing is completed
Battery Balancing Steps
For bad cell: Replace the cell Fully charge the new batteryStart balancing Fully charge Battery maintenance is completed
Nondestructive cell: Fully charge Balancefully chargeBattery maintenance is complete
Some
balance can not reach the effect because the cell is much old, it can
be repeated above steps for many times to reach the target
Matters needing attention
1.
Due to the large balance current, so the balance wire should be thick
enough, otherwise the wire will be burned or other problems will occur
2.
The withstand voltage of single string batteries input interface (it’s
the upgraded version: -100V~+100V), it will damage the device if the
voltage exceeded (we can help to repair but customer need to pay for the
shipping), please pay more attention when wiring
3. The B- is the
negative polar of the battery pack, and the B1 is the first string from
negative polar, don’t connect to other batteries whilst balancing
Note: Please double check the wirings before connecting to the balancer, there will be a risk if wired with reverse polarity