Famicom AV Mod Kit makes your Original Nintendo Family Computer to output AV Composite Video


Removing the existing POWER & RF board and install this kit completes the job. No cutting of housing is required to install connector on the your precious Family Computer.


Setup :

1. Remove of phillips screws and bottom cover lifts right off

2. Disconnect two controllers from the mother board

3. Remove of all phillips screw from the mother board and power board. Remove two more phillips screws of power switch

4. On the power board. Desolder the 7 wires that connect the mother board to the power board

5. Place Mod kit and solder 7 wires on it

6. Solder line of Power Switch

7. Place 3D printing for gap filling and secure controllers, mother board and Mod Kit with phillips screws

8. Close the bottom cover and screw it with phillips screws


Features :