Will never rot unlike wooden weather bars
We have been manufacturing & installing windows, doors & glass for 29 years.
We only sell tried & tested products that we use on a daily basis
Made in the UK
This aluminium drip bar can be fitted to uPVC, wood, aluminium and composite doors.
Very simple to fit,
Measuring& Fitting Instructions:
Simply cut the drip bar to the required length (with a junior hack saw), width of door sash for best results the bar should finish approx.5 - 10mm from each end of the door frame when closed
Fitting tip:
Place the bar in position, we recommend using a spirit level to get it level then mark the holes using a pencil through the pre-drilled holes in the bar this will allow you to pre-drill a pilot hole if required
or using a battery driver the screws can be fitted without marking or pre-drilling.
The bottom of the drip bar should be about 15mm above the highest part of the bottom of the threshold that the door seals to when closed.
This allows for any expansion or movement you may experience over the years. The end caps may require a contact adhesive, super glue or silicone and push to fit.
Specification
Exact product colour displayed may vary depending on setup and quality of the device used to view.
Open Monday - Thursday 7.30am - 4.30pm
Friday 7.30am - 1.30pm