Bent Tap Connector - 15mm x 1/2 inch. Pack of 5 Unbranded with washers
Bent
Tap Connector - 15mm x 1/2 inch solder ring. Pack of 5 Unbranded with washers
Solder Ring capillary fitting is manufactured to BS EN
1254-1. This fitting joins copper tube manufactured to BS EN 1057 using
lead-free pre-soldered fittings.
It is suitable for above ground hot and cold domestic or potable water
services, central heating systems, low-pressure steam heating and pressurised
unvented heating systems. It is equally suitable for sanitation services and
compressed air lines, gas distribution systems for natural and manufactured
gases.
A solder joint is created through the principal of capillary action, when the
fitting and tube is assembled and heated to the appropriate temperature, solder
becomes molten and is drawn into the gap between tube and fitting for a durable,
reliable joint. It is recommended soldering flux is also used to aid this.
Manufactured from copper
For use on hot and cold water systems
Neat, tidy installation when installed
by an experienced fitter
System covers all aspects of gas and
heating systems in domestic and light commercial applications
Requires a blowtorch.