Item: Parallel Load Board
Balanced Output Cable: 18 awg silicon cable
Current: Supports up to 35A load current
Supports 4 groups of 2 S, 4 groups of 3 S, 4 groups of 4 S, 4 groups of 5 S, 4 groups of 6 S, 4 groups of 7 S, and 4 groups of 8 S balanced loads.
I. Features
1, can support up to 4 groups of the same type, the same number of sections of the 2-6S battery pack.
2, balanced port output line using 18AWG multi-strand silicone wire.
3, Equipped with safety protection T-plug silicone cap.
4.High quality gold-plated connectors.
5, Thickened PCB copper foil, support up to 35A charging current.
6, Any two groups of batteries are configured with a 40A fuse between the batteries, to prevent the line burned out due to the battery pressure difference caused by too large.
Second, the use of instructions.
1, the use of this parallel charging board can be no more than 4 groups of the same number of sections of lithium battery packs at the same time for balanced charging. Avoid the tedious operation of replacing the battery charging many times.
2、Multi-slice monomer battery cells are connected in parallel with each other, the average pressure difference between the cells is smaller after weak discharge, which can effectively shorten the charging balance time.
3、Single group charging needs 4 times balancing, using parallel charging board only needs one balancing, charging time is greatly reduced.
4、When 4 groups of batteries are connected in parallel at the same time, even batteries that do not support high C-count charging can be safely balanced and charged at 4 times the original single-group charging current, effectively shortening the charging time.
[Parallel charging, the number of battery sections (S number) unchanged, the capacity of the superposition, such as two 4S 5000mAh batteries in parallel, it becomes a 4S 10000mAh batteries, parallel 4, it becomes a 4S 20000mAh batteries, 1C charging can be supported by 20A)]].
Notes.
1, when the battery is connected to the parallel charging board, connect the main output first, and then connect the balance head, the starting voltage difference should not be too big (it is recommended that a single section does not exceed 0.1V ), otherwise the fuse may be blown.
2, when charging batteries with parallel charging board, each connector is charged, please cover the unused T-head with a silicone cap, or be careful not to drop metal objects into the interface to avoid short-circuit accidents!