These are steel fingers that work on a linear bow press. The mounting hole is cut at 7/16 inch (11.12mm) so that they can be drilled out cleanly to a 1/2 inch (13 mm).

These are straight out of the laser without any prep. You will find it necessary to clean them up. 

Mounting blocks that are designed for bow press fingers. These mounting blocks are machined from solid 6061-T6 aluminum for maximum strength and durability. 

The installed hardened 1/2" (.500") pin is a pressed fit. There are two countersunk holes to accommodate mounting (not included) screws. The threaded screw hole can be used to secure a spacer (not included) if needed.

These parts are straight out of the CNC machine and may need a bit of touching up. The milling marks and minor flaws are visible but not to bad. 

You will receive two mounting blocks (one set) as pictured. No screws are included.

Proudly made in the USA