4PCS*Tire Pressure Monitoring System Sensor
Loosening the tire:Lift your car, remove tire and the valve stem core to allow all the air to escape, then strip away the tire. | Dismount the sensor
| Mount sensor and valve
| Mount the tire
|
HOW TO RELEARN THE TPMS SENSOR
Need a tire pressure activation TPMS tool [EL-50448,ATEQ(VT41.VT46.VT56),AUTEL(TS408.TS508) etc.]
一:OBDII RELEARN
1.OBDII connector is required.
2.Confirm TPMS sensors are properly installed.
3.Adjust tire pressures to placard value.
4.Activate TPMS Tool on left front tire sidewall next to the valve stem.
5.Repeat for RF/RR/LR tires.
6.Apply OBD connector to DLC.
7.Turn ignition to ON
8.Press OK on TPMS Tool to transfer data to ECU
9.Disconnect OBD connector from DLC
10.Turn ignition to OFF then start the engine
11.Drive for at least 5 minutes at 28mph.
二:MANUAL RELEARN
1.OBDII connector is not required.
2.Confirm TPMS sensors are properly installed.
3.Adjust tire pressures to placard value.
4.Apply parking brake
5.Turn vehicle to ON/RUN
6.Scroll the uplevel on the right side of the steering wheel until Tire pressure is displayed---with Uplevel DIC
(Push the trip odometer reset stem until tire pressure is displayed.—with Base level DIC)
7.Push and hold Set/Reset button---with Uplevel DIC
(Push and hold trip reset stem to begin the sensor matching process,push trip reset again to confirm--- with Base level DIC)
8.Horn chirps 2x,DIC displays TIRE LEARNING ACTIVE
9.Use tool to activate LF sensor
10.single horn sounds