SPECIFICATIONS

ELECTRICAL

Data Interface IEEE 802.3 Ethernet

Data Rate 10/100Mbps

Operating Mode Half or full duplex

Data Connector RJ45 mounted on the front panel

PoE 46 to 50V @ 0.4Amp maximum

Operating Modes Alternative A (Pins 1/2 and 3/6) And Alternative B (Pins 4/5 and 7/8)

OPTICAL

Optical Interface 100BaseFx

Optical Port Connector SFP (LC connectors for 2-fiber operation and SC for 1-fiber operation)

SFP Options OSDSFP100Fx: 2 fiber, SFP Plug-in Transceiver @1310nm OSDSFP100WFxA: 1 fiber, SFP Plug-in Transceiver (Tx @1310nm, Rx @ 1550nm) OSDSFP100WFxB: 1 fiber, SFP Plug-in Transceiver (Tx @1550nm, Rx @ 1310nm)

Transmit Optical Power -15 to -8dBm into singlemode fiber (See SFP datasheet for details)

Receiver Sensitivity <-33dBm

Receiver Saturation >-3dBm

Standard Optical Link Budget >18dB: >10km on multimode fiber @ 1310nm >40km on singlemode fiber @ 1310nm

NOTE: Special configurations to cover longer distances are also available. Contact OSD for a full listing of available options.

PHYSICAL

Operating Temperature Range -20 to +75ºC, derated by 2ºC per watt supplied over the Ethernet cable. Reduces to +45ºC when connected to a 15W load

Relative Humidity 0 to 95% non-condensing

Power Requirements +10V to 35V DC or 22 to 28VAC @ 2VA plus up to an extra 20VA for POE operation (attached powered device dependent)

Power Connector 3.5mm 2-way terminal block on the module

Indicators TP activity TP link speed Power indicator Fiber link activity PoE operation

Dimensions of Module (mm) 52W x 55D x 26H

Weight of Module (kg) 0.3