Please note: This carrier board is not compatible with Intel Edison, and does not come with an Intel Edison installed. This carrier board does not come with the Edison Debug or Standard Debug micro USB ports. Basically, if you want to use this with Intel Edison, don't buy it. Otherwise, it is a fully capable ArduPilot flight controller.

Cube/Standard Carrier Board

The standard carrier board allows you to break out the full functionality of the Pixhawk 2 Cube flight controller, plug and play ready.

Features

• 2 Power ports
• I2C Port
• Dedicated Spektrum RX port
• ADC Port
• CAN 1/2 port
• 2 Telemetry ports
• S.Bus/PPM

INSIDE THE PIXHAWK 2 CUBE 

• An STM32F427 Rev 3 Flight management unit. (where the flight controller lives.)
• An STM32F100 I/O processor with pass through capabilities for failsafe. (deals with the Receiver and outputs )

3 IMU's

• 1 Fixed 10 Axis IMU on the main Main board.
• (MPU9250 3 axis Accell, 3 axis gyro, and 3 axis mag, MS5611 Barometer)
• 2 Vibration Isolated and heat controlled 9DOF IMU's and an isolated Baro.  
• (MPU9250 3 axis Accell, 3 axis gyro, and 3 axis mag, LSM303D 3 axis Accelerometer, 3Axis Magnatometer, L3GD20 3 Axis GyroMS5611 Barometer     
• In case you missed it.... 3 IMU's STANDARD.
• Size: 38x38x22mm 

all connections are via an 80 pin DF17 connector on the base.