This CNC kit included:
- 3 x Closed Loop Stepper Driver 0-8A 24-48VDC for Nema 24 Stepper Motor
- 3 x Nema 24 Closed Loop Stepper Motor 4.0Nm/566.56oz.in Encoder 1000CPR
- 1 x 500W 48V 10.5A 115/230V Switching Power Supply
- 3 x 1.7m Long Encoder Extension Cable for Closed Loop Stepper Driver
- 3 x RV-4 AWG18 1.7m Long Motor Extension Cable with GX16 Aviation Plug
1 x RS232 Debugging Cable
Motor Specification
Part Number: 24HS40-5004D-E1000
Number of phase: 2
Holding Torque: 4Nm(566.56 oz.in)
Rated Current/phase: 5A
Phase Resistance: 0.6ohms
Inductance: 2.6mH ± 20%(1KHz)
Frame Size: 60 x 60mm
- Full Length(with Encoder): 125mm
- Body Length(without Encoder): 100mm
Shaft Diameter: 10mm
Shaft Length: 21mm
D-CUT Shaft Length: 15mm
Lead Length: 300mm
Encoder Specification
Output Circuit Type: Differential type
Encoder Resolution: 1000
Output Signal Channels: 3 channels
Supply Voltage Min: 4.5V
Supply Voltage Max: 5.5V
Output Current: 100mA MAX
Output High Voltage: ≥Vcc-0.4V
Output Low Voltage: ≤0.4V
Output Frequency Max: 1.85MHZ
![](https://pg-cdn-a2.datacaciques.com/00/MTAwOTk4/21/04/29/8pv9lk7t2psww674/e8e79d1a558afae9.jpg)
Driver Specification
Switching Power Supply
48V DC 10.5A output
AC input voltage range: 92~132V/180~264VAC
115V/230V AC selected by switch
High efficiency low cost
Forced air cooling by built-in DC fan
Low output ripple and yawp
Over current, over voltage, short circuit and overheat protections
215*115*50mm (L*W*H)