This new kit combines the clutch and the throttle kit in handy storage box. 

Typical application: motorcycle clutch cables, throttle cables and choke cables. Supplied with 2 sizes 10m long of Teflon lined very low friction conduit, with a black PVC cover, 2 sizes 10m long inner wire. A range of nipples and high quality fittings are also included. The ferrules and bends are a snug fit on the conduit. They can be bonded in place during the assembly, or crimped / retained with a small centre punch indentation to their side. The fittings can be adapted for a range of models. There are enough fittings in the kit to make at least ten lines (5 clutch and 5 throttle). Additional fittings, conduit and wire can be purchased separately as required. You will need a basic soldering kit to solder the nipples in place. We recommend our ‘bird caging’ tool  VT13 to make the bond with the nipples stronger prior to soldering. Part no. VT13 is  also available in our eBay shop.

The kit includes:

Wire Materials

• 10 meters (30 feet) of 5mm OD conduit with Teflon™ liner, black PVC coated
• 10 meters (30 feet) of 7mm OD conduit with Teflon™ liner, black PVC coated
• 10 meters (30 feet) of 1.5mm OD galvanized steel wire (7 x 7 strand)
• 10 meters (30 feet) of 2mm OD galvanized steel wire (1 x 19 strand)

Nose Ferrules

• 20 ferrules for the 5mm conduit, 1/4" OD
• 40 ferrules for the 5mm conduit, 5.5mm OD
• 10 ferrules for the 7mm conduit, 8mm OD nose
• 10 ferrules for the 7mm conduit, 6.5mm OD nose
• 10 ferrules for the 7mm conduit, 7mm OD nose

Bent Ferrules

• 3 alternative bent ferrule, throttle open
• 3 alternative bent ferrule, throttle close
• 2 bent ferrules, 45 degree

• 2 plastic wire guides, 1 female, 1 male

Adjusters

• 3 mid 6mm x 1.25 x 32mm
• 3 mid 6mm x .75 x 20mm
• 3 6mm x 1.0 x 32mm
• 3 8mm x 1.25 x 42mm
• 3 aluminum 8mm x 1.25 x 25mm

Nipples

• 10 brass barrels, 10mm DIA x 10mm
• 10 brass barrels, 8mm DIA x 9mm
• 10 brass barrels, 6mm OD x 10mm
• 10 brass barrels, 6mm DIA x 5mm
• 10 brass barrels, 3/8" DIA x 1/2"
• 40 brass carb nipples, 3mm DIA x 3mm
• 25 brass trumpets, 8mm big end, 4.5mm small end, 10.9mm long, 2.5mm ID
• 25 brass trumpets, 6mm big end, 3.5mm small end, 5mm long, 2.5mm ID
• 25 brass trumpets, 6mm big end, 3.5mm small end, 9.5mm long, 2.5mm ID
• 25 brass balls, 5mm DIA

Rubber Boots

• 10 general use boots
• 20 adjuster boots, 7mm ID
• 4 tapered boots, 10mm big end, 6mm small end
• 1 push/pull guide boot