USB Programming Cable for Motorola APX8000 APX9000 XPR7550 XPR7550e XPR7580 Description Condition: New Cable Length: 1M / 39.37 inch Connector Type:USB Type A NO RIB BOX required!! This listing’s photos for a close-up of the connector to ensure that this cable matches the physical characteristics of your radio’s programming port before ordering this cable. Most radios use the microphone jack as the programming port but some have a separate data port for programming and/or PC to internal TNC interface. It is important to know that programming cable use fewer signal pins than a microphone so the pinouts are typically simpler than your microphone cable. No Programming Software is implied or promised with this cable. You need to make sure that the operating system (OS) 32-bit and/or 64-bit you have are supported by the programming software you are going to be using. The older the programming software and radio are the more likely you will need a 32-bit OS to actually communicate with the radio. Fits: For Motorola Radio Models: For XPR Series: XPR6300 XPR6350 XPR6380 XPR6500 XPR6550 XPR6580 XPR7350 XPR7380 XPR7550 XPR7550e XPR7580 For XiR Series: XiR P8200 XiR P8208 XiR P8260 XiR P8268 XiR P8608 XiR P8620 XiR P8660 XiR P8668 For DP Series: DP3400 DP3401 DP3600 DP3601 For DGP Series: DGP4150 DGP4150+ DGP6150 DGP6150+ DGP6150 DGP6150+ DGP5050 DGP5550 DGP8050 DGP8550 For APX Series: APX2000 APX4000 APX6000 APX6000XE APX7000 APX7000XE APX8000 APX9000 APX8000XE Package Content: 1× USB Programming Cable NOTE: Please check carefully if your ORIGINAL item looks exactly the same on our photo before purchase.