NEW 24 VOLTS MAINS POWER SUPPLY FOR NAGRA MONO or STEREO REEL-TO-REEL TAPE RECORDER see Note

Can be supplied in 30 volt but then cannot be use on the Nagra III

Works with NAGRA MODEL: - 3, 111, IV, IV.L, 4.2, E, D, IV-SJ, IV-S & IV.S TC,

THIS IS A SWITCH MODE REGULATED POWER SUPPLY THAT WORKS FROM 100 TO 240 VOLT AC, 50Hz OR 60Hz MAINS SUPPLY, WITH A -24 VOLTS DC 1.2 AMP 45 WATTS OUTPUT WITH A 6 PIN BINDER PLUG TO FIT THE NAGRA, AND WILL NOT ADD NOISE TO YOUR RECORDINGS.

THIS IS AN EQUIVALENT POWER SUPPLY TO THE ATN NAGRA POWER SUPPLY AND WILL WORK IN ALL COUNTRIES.

Note: I will supply a mains lead with plug to use in your country,

This power supply has an IEC 8 mains leads input, with no earth as this power supply has a floating -24 volt DC output and is insulated for mains and earth,  you will not have a problem using with a Nagra, and the Nagra will be earth from the other equipment.

Please note

Don't use this type of power supply that has a 3-pin IEC with earth, and is connect to a Nagra and to other equipment which is also connected to the mains with an earth, you will get an earth loop buzz, or the power supply will trip off, or you could damage other equipment you are connecting to, 

The ATN Nagra power supplies has an isolating transformer on its output so the earth is only needed for the metal case and will not connect to other equipment, so no problems you can use a 3-pin IEC mains connector cable

THESE POWER SUPPLIES MEET CEC & ENERGY EFFICIENCY LEVEL V REQUIREMENTS, ARE CE & RoHS COMPLIANT, AND HAS AUTOMATIC BUILT IN SHORT CIRCUIT, OVER VOLTAGE AND OVER CURRENT PROTECTION

CuL, UL, PSE, TUV, GS, CE, BSML APPROVED

BUT IT'S ALWAYS BETER TO USE AN ATN TYPE NAGRA POWER SUPPLY WITH A PERFECT SINE WAVE