An awesome set of headlights not only enhances the overall appearance of your vehicle, but also helps you navigate in rain or shine. Our high-quality lights are made from durable ABS and hard-coated polycarbonate and feature luxury designs that will transform your vehicle's appearance.

 

Material:
ABS Plastic + Polycarbonate Lens.

 

Position:
Front Left & Right

 

Color:
Chrome Housing + Clear Lens + Amber Reflector

 

 

Features:
- 100% brand new in factory original package.
- Made of high grade OE comparable materials to withstand rough road wear and the test of time.
- The special housing is durable, resistant to water, impact and corrosion.
- Brings a different appearance to vehicle thats great for show use or to replace old and worn lights.
- Precise fitment with simple, bolt-on installation. No modifications needed

 

Note:
- Professional installation is recommended
- Installation instruction and hardware are not Included

 

Compatible with the following vehicles:
2005 - 2010 Chrysler 300
Does Not Fit Chrysler 300C / SRT-8 / Factory HID

 

Package included:
Pair Headlight Driver & Passenger Side

 

 

Adjust：
Before you begin to adjust the light, make sure check the alignment of your lights first. Park the vehicle about 10 to 25 feet from the wall with the lights aimed at the wall. The centerlines of the headlights should not be any higher than 3.5 feet above the ground.
1. 【Find the adjustment screws】Firstly, locate the adjustment screws on your vehicle.
2. 【Adjust the headlights individually】The headlights should be adjusted one at a time. Put a rag or towel over a chair in front of the light you want to block. Covering the light assembly directly can damage the plastic lens.
3. 【Adjust the vertical field】The screw on the top of the light housing should be turned clockwise to raise the lights and counterclockwise will lower the light. The headlight should be adjusted until the top of the most intense part of the light beam shines directly on or just below the center of the tape line on the wall.
4. 【Adjust the horizontal field】The screw on the side of the light housing should be turned to get the right/left adjustment correct. Adjust the lens so that the most intense part of the beam is to the right of the vertical line.
5. 【Test your results】