Admit it! We’ve all gone through menace of tackling leaky, smelly, and all the more flimsy plastic spigot. But, not anymore! If we see, our common pain points with a plastic spigot can be segregated into the following kinds
1. Plastic spigot leaks and if you tighten, it breaks.
2. Breaks very easily and in a short span of time.
3. Unattractive.
4. Difficult to maneuver.
5. Plastic pollution and recycling is an issue.
6. Crud can settle with time on the surface leading to pungent odor in the beverage.
7. Over time lose the ability to seal
So if you have to upgrade, replace, improve water quality, or the beverage taste, have this stainless steel dispenser by your side. Because your old and degraded spigot can cause you health issues and impact your growth adversely.
Curved Angle | Mesh Filter | Strong Handle | No-leak Seal |
Having a fast, efficient drinks dispenser on hand is perfect for keeping hydrated all day long. Whether your choice of beverage for staying hydrated is water, cold-brewed coffee, tea, beer, or perhaps you like to have wine on tap, this stainless steel spigot by Vila is the way to go!
It's super easy to install, and comes with a silicone washer/gasket which restrains any leaks and can withstand heat up to 390°F (200°C). It is much more durable than plastic spigots that usually come with your mason jars, kombucha jars, or water crocks. The durable water dispenser replacement faucet can handle a 5-gallon water tank and dispense a continuous flow of water almost as well as your kitchen basin. With a twist of the knob, you can maneuver the water flow.
The metal spigot is made with 304 stainless steel which makes it durable to use for years to come. This faucet will make dispensing the brew easier than pouring from the top of the jar or using ladles and siphons which just makes the work messier. Just make sure you run water through the spout if you use it for sugary drinks because they are so easy to disassemble and reassemble. Your metal and glass jar faucet will last a lifetime if you take proper care of it.
Gather all parts | Assemble them in order | Hold Spigot and tighten the last nut | Your Dispenser is ready to use |
How To Install:
Please take note that this Beverage Dispenser Replacement Spigot requires 5/8 inch or 16mm diameter opening to install. It fits any dispenser wall which is up to 0.62" or 16mm thick. The rubber washers need to be against the inside and outside surface of the glass to create a good seal. Keeping this in mind, you can convert even the tiniest of mason jar into a dispenser.
Specifications