Feature:

1. Superior Performance: High performance microcontroller board with flexible digital interface. The for Pico Boot has two ARM Cortex M0+ cores up to 133MHz; 256 kb of RAM; 30 GPIO pins; and a wide range of interface options.
2. Compatible: Can run on any version of the for and for Wii consoles. Easy use of your idle micro storage card, which needs to be used with for swiss, for xeno, for GCloader Lite, or for pcioboot, automatically loads the micro storage card game list with a maximum memory of 512GB, plug and play.
3. Rich Software: The Microcontroller board has rich and complete software support, it comes with full compatibility with official for RPi C C++ SDK, for Micro for python SDK. It also comes with 16MB of on board QSPI flash memory for code and data storage. The maximum operating current can arrive 500 mA.
4. Multi Function: Mainstream devices support USB TYPE C interface; The Classified module allows soldering directly to the carrier board One button reset button function, quick and easy, low power sleep and hibernation modes, use via USB, mass storage for drag and drop programming.
5. Full Kit: For RPi Pico has 26 × multifunction GPIO pins, 2×SPI, 2×I2C, 2×UART, 3×12 bit ADC, 16× controllable PWM channels, accurate clock and timer on the chip, temperature sensor, accelerated on chip floating point library, 8 × programmable I/O (PIO) state machine, custom peripheral support.
6. Small and Compact: The microcontroller board has an ultra small size of only 2.1x5.1cm / 0.8x2.0in (as small as your thumb). The design for Pico can be used either with a soldered 0.1" needle or as a mounted "module".

Specification:

Item Type: For RPi Microcontroller Board
Material: PCBA
Size: Approx. 5.1x2.1x0.4cm / 2.0x0.8x0.2in
Interface: USB C
Processor: Dual Core for Arm Cortex M0+ Processor
Chip: for RPi RP2040 Microcontroller Chip
On Board Flash Memory: 16MB
SRAM: 264K
Maximum Operating Current: 500mA
for Card Reader: Micro Storage Card (Maximum 512G)
Features:
Official For RPi Pico Module
Easy To Install, Only 5 Wires Needed For Soldering
Detailed Soldering Tutorial And Video Instructions
Programming Via USB Cable, No Drivers Or Programs Required
Automatically Launches Any DOL Application Of Your Choice (Switzerland)
Uses The "IPL Injection" Method Which Is Superior To Mods Like for XenoGC
Complete Replacement For XENO+SWISS Boot Disk Method Of Operation
26 x Multifunction GPIO Pins
2 x SPI, 2 x I2C, 2 x UART, 3 x 12 Bit ADC, 16 x Controllable PWM Channels

Package List:

1 x for Picoboot Development Board Copied Program

5 x Electronic Wire 

1 x Heat Shrink Tube 

1 x Plastic Bracket

1 x Double Sided Adhesive

4 x Silicone Film

1 x for Card Reader

Note:

Please allow some error in manual measurement.