AE Factory Team RC10 T4.2 Assembled Kit in good used condition
This kit has been used, but well maintained.
The transmission spins freely and the shocks cycle smoothly.
Included installed electronics as follows:
Hobbywing JustStock Club Spec Sensored Brushless ESC: (please note limitations below prior to use)
Specifications:
Output: Continuous 45A, burst 260A.
Input: 4-9 cells NiMH/NiCd or 2-3S LiPo.
BEC: 6V@2A linear mode built-in BEC.
Resistance: 0.0006 Ohm.
Motor Supported: Sensored and sensorless brushless.
Cooling Fan: 5V (The cooling fan gets its power supply from the built-in BEC)
Suitable Motor:
- With 2S Lipo or 4-6 cells NiMH, 1/10 on-road>=8.5T, 1/10 off-road>=11.5T
- With 3S Lipo or 7-9 cells NiMH, 1/10 on-road>=13.5T, 1/10 off-road>=17.5T
TrakPower 8.5T Brushless Motor
Spektrum S6070 Low Profile Servo
You will receive the item exactly as it is depicted in the photos and video.
The body is in good shape, with just a few scratches inside in the usual spots around the shock towers. I tried to show them in the photos. They are barely noticeable with the body on.
Transmitter, Receiver, Battery and wheels/tires NOT included and are required to run.
Features
- Factory Team 12mm Big Bore hard-anodized aluminum threaded shocks with TiN "Gold" 3mm shock shafts
- VTS slipper (variable torque, multi-plate slipper with three drive surfaces) assembly featuring a high-resolution spring
- Factory Team 12mm blue aluminum front and rear clamping hexes with hex wheels
- Factory Team 7075-T6 blue aluminum 0 deg. rear hubs with oversized outer bearing
- Factory Team blue aluminum bellcrank set
- Updated shock towers optimized for the 12mm Big Bore shocks
- Ball differential with light-weight outdrives
- Factory Team blue titanium turnbuckles
- Factory Team carbon-fiber battery strap and blue aluminum thumb screws
- CVA joints with pin retainer clips
- Factory Team rear ballast weight
- Complete set of precision ball bearings
Thanks for looking!
Due to the nature of the hobby, returns are not accepted on this item.