The last batch of aftermarket Toyota 20-22 yokes from the manufacture were machined improperly.
After ordering 10 pieces and confirming all of them having the same defect.
There was a fitment issue where the yoke was too tight on the output shaft of the transmission.
This is a substitute yoke that was custom machined to fit from a different application.
The result is this yoke uses a larger 7290 model u-joint rather than the previous smaller 1310 u-joint.
I have made and shipped 4-5 of these modified units with positive feedback from the customers.
If you have any questions feel free to message me.