Item 1: Ford MODEL B DISTRIBUTOR 1932 - Refurbished using new points and condenser
Item 2: Model A Timing Cover Plate - Modified for Model B Distributor use.
Item 1: Refurbished Model B Ford Distributor.
This distributor was disassembled, cleaned. It was previously painted POR-15 epoxy paint so I didn't remove it. Brass bushings were pressed in and the holes reamed for straightness on a lathe.
The side oilier was
removed and the passage cleaned out.
The points are set at .018 gap per Ford spec.
The Timing Cover Plate is drilled using a professionally built drill jig that adds a hole for the 3/8-16 THD timing pin.
This adds 9 degrees advance to the Cam Shaft Top Dead Center position and 18 degrees advance at the Crankshaft.
Thank you for looking,
Kenny777
Check my feedback for references!