ATTENTION: The price shown includes Greek VAT 24% and is applicable to all individuals in EU countries only. If you are from any other country including USA, Canada, Australia etc. please use the "make offer" button and divide the price by 1,24.We will first accept this offer to let you proceed with the check-out and payment. If you are a business registered in EU with a valid VAT number again, you can use the same button so to pay without VAT. We will send you a zero VAT tax invoice.

Miniature HF Band-Pass Filter

   5% 0402 or 0603 NPO Capacitors

​

   Adjustable inductors

   Available for all individual HF amateur bands

​

These filters are of the same design as used in my Ham-Bands Preselector, but many friends emailed me to make individual single-band filters to be placed into their own projects of receivers, single or dual or triple band transceivers etc., where the preselector board is so large to fit, or expensive since it has all those relays. While the design is simple, offering those mini filters requires a lot of work, but it has been done already and we are able to serve those needs and we now have them available for shipping.

A miniature high-quality PCB has been produced, the capacitors and special inductors have been ordered and some DIY KITs are now ready. Each of them has a unique code number to help us keeping track of the inventory of the components and ensure error avoidance.​ There are 9 filters available, one for each of the Amateur Radio HF bands and a 10th is getting ready for the new 5 MHZ band. Each of them is offered as a DIY KIT or ready-made and tested. They can be used in receiver input stages, before a preamp and maybe a second after the preamp, to make switched preselectors or multiplexers. They can only work with low-level transmit applications at mW level to clean up VFOs, mixers before a power amplifier, for experiments and measurements. Especially cleaning RF signal generators for IMD measurements.  Aligning the filter is very easy, by adjusting the two variable inductors with a ceramic or plastic slot-tip screwdriver.​

The PCB is of highest quality, with 1-oz copper layers, gold plated and 0.8 mm thick FR4 but minimal in size so to be able to fit into your project. Between the two variable inductors there is a 3 mm hole for a supporting screw. The input and output ports have three 2.54mm spaced pads with holes, so ordinary pin-headers can be used for mounting them.

ORDERS For a complete DIY KIT

Check out my other items! I always combine shipping.