Insert Information
Manufacturer	SANDVIK
Insert Code	CNMG 12 04 08-WF
ANSI Code	CNMG 432-WF
Insert Grade	1525
Grade ISO Range	P15 (P05-P25)
Insert Material Type	PVD Coated Cermet
Grade Description	P - A PVD coated Cermet. Very high wear resistance and good edge toughness. For finishing and semi-finishing of Low Carbon and Low Alloyed Steels. To be used when good surface quality is demanded at medium to high cutting speeds. fn x ap < 0.35mm2.
Geometry Information	WF geometry is a Sandvik finishing Wiper geometry. The geometry allows double the conventional feed rates with the same surface finish or a surface finish that is twice as good at the same feed rate.The higher feed rates also give the advantages of improved chip breaking and can also give improved tool life (more components per cutting edge) due to the shorter cutting edge engagement time. An ideal insert when good surface finish is a priority with the potential to replace grinding operations. A geometry which provides a combination of high feed and good surface finish in Steel, Stainless Steel and Cast Iron.
Quantity Supplied	1 Pack of 10 Inserts.
Condition	The Inserts are New/Unused and the Boxes are Sealed.
DISCLAIMER
The technical information provided in this listing is for general guidance only and has been taken from literature provided by manufacturers. Every reasonable care has been taken to ensure this information is accurate and correct and we do not accept any responsibility or liability for errors or omissions or any information that is found to be misleading. For more detailed technical information and to check this information please consult the manufacturers own literature or websites which in general have an extensive array of technical literature available.