Adjustable Holder Support Mount Fit For 55-80mm CO2 Laser-Tube Engraving Machine
Adjustable Holder Support Mount Fit For 55-80mm CO2 Laser-Tube Engraving Machine

Specifications:
Condition: new
&
ABS Plastic & Rubber & Metal
Size: approx.11.5x6.5cm(4.61x2.64inch)(LxW)
Height: approx.10-16.5cm(3.94-6.50inch)
Item included: 1 x CO2 Laser-Tube Holder


How to use: Put four screws on the four oblong holes at the bottom of the tube bracket to fix it on a flat Put the laser-tube and adjust the tube bracket to make the height of the laser-tube appropriate and form an angle of about 45 degrees with the reflector next to the light emitting end of the laser-tube. After adjustment, tighten all screws of the tube bracket.

Features:
The diameter of the tube is adjustable, suitable for laser-tubes with a diameter of 55-80cm, to avoid the tube holder not being
Use special plastic, the material is not aging, the laser-tube can be fixed firmly, and the optical for is not easy to deviate;
Lifting screw, easy height adjustment; simple installation;

Note:
1) All dimensions are measured by hand, there may be small deviations.
2) Color may vary slightly due to the color setting of each individual monitor.

Package included:
1 * Adjustable Holder Support Mount