This is a used original steering wheel taken off of a 1957 Chevy Bel-Air 2 door sedan.  This will fit all the '57 Chevy passenger cars.  It is used and has some cracking in the rubber/plastic (not sure which it is).  So, those cracks will need to be filled in, sanded down, and then the wheel repainted to match your car.  This one started out as Turquois, but as you can see in the pictures most of the paint has worn off.  It doesn't look to be bent (see next to last picture where it is laying down flat against the concrete) and the splines where it attaches to the steering column look to still be in good shape too (see picture #4).  Other than the cracking, the one other flaw I know of is when I put the steering wheel puller on it to take it off, the threads in one of the steering wheel puller holes was very rusty and the threads pulled out.  I taped that one hole out to an M9 x 1.25.  If you want to make them consistent, you could drill and tap both out to a 3/8" hole.  I didn't do that because I have a small steering wheel puller and the 3/8" bolts wouldn't fit in it.  They were originally both 5/16", but you would only need those holes to remove the wheel in the future - they aren't needed to install it.  Note: I have the shipping as Priority.  I will ship it Parcel Select (ground) if you prefer.  I have to put it as Priority because the shipping calculator doesn't give the correct post office price for Parcel Select.  If you sell as well as buy on Ebay, you'll already know all about that.  If you want to see want the Parcel Select price would be you can go to usps.com and put in the dimensions for the package as 18" x 16" x 13" and weight of 8lbs - 6oz and shipping from 27565 to your zip code and you can see what the shipping cost for Parcel would be.  If you don't mind the longer delivery time and want to go that route, let me know after the auction ends and I can refund the difference in shipping cost between Priority and Parcel Select.  Please contact me if you have any questions and thanks for looking.